Slate Roof Repair History
     

  • SLATE ROOF REPAIRS, HISTORY OF - CONTENTS: How to spot previous repairs to a slate roof . Types of repairs to slate roofs that can be seen from the ground, from roof edge, or from closer inspection points. How do previous roof repairs help track down current roof leaks or troubles in a slate roof? How does the roof repair history help decide on the remaining life of a slate roof or the cost to maintain a slate roof
  • SLATE ROOF REPAIRS - separate article
  • SLATE ROOF INSTALLATION QUALITY - separate article
  • POST a QUESTION or READ FAQs about assessing a slate roof condition by observing its repair history
  • REFERENCES

InspectAPedia tolerates no conflicts of interest. We have no relationship with advertisers, products, or services discussed at this website.

Slate roof repair history: the repair history of a slate roof can help you assess the remaining roof life, roof condition, probable roof leak points, and the expected cost of maintaining a slate roof. Here we include photos and text that help a roof inspector or building owner spot where repairs have been made to a slate roof, why the repairs were made, what was probably wrong, and what, thus, is the overall condition of the roof.

Green links show where you are. © Copyright 2015 InspectApedia.com, All Rights Reserved.

Slate Roof Repair history helps diagnose the condition of a slate roof

Dutch lap slate roof in Vermont (C) Daniel FriedmanTar or roofing mastic is normally an indication of improper maintenance. It should be considered a temporary, unreliable repair. Tar or roofing cement should not be found at chimneys, sidewall flashings, plumbing vents, or elsewhere.

Our photo at left shows tar patching in the dormer valley and below the dormer. But further loose slates are falling off of this roof, possibly damaged during application of the valley tar.

The tar itself usually remains effective as a sealant only for a year or so. While in place, tar traps moisture within the slates, causing the slate itself to deteriorate. When flashings leak on a roof they should be repaired or replaced as necessary, without using roof cement.

Copper tabs and fastener failures on slate roofs: Watch for numerous copper tabs at the center of replacement shingles. These indicate that repairs have been made and they may be a clue about the overall condition of the fasteners. In a first-class slate repair you should not be able to see the copper tabs. The Old-House Journal April 1984 roofing issue describes an alternative method for securing slates which will leave a copper tab exposed. Expert roofers have a less visible method of fastening the replacement slate. [See "Repairing Slates" sidebar article.]

Our page top photo shows a perfectly good repair made by sliding a piece of copper flashing up under slates to cover a hole that may have been made by a nail pop from below.

Asphalt shingles applied over slate roofs: Using asphalt over slates is surprisingly common "re-roof" procedure as it avoids labor and disposal costs for the slate material. [In some areas of the Northeast it also represents the popularity of lower-cost asphalt and the dearth of experienced slaters who might have repaired the slate roof.]

When nailing the asphalt shingles it is common to find only a poor bond of new nails to original roof decking. The slates below tend to chip and bulge the new material resulting in a "peanut brittle" or "popcorn" effect. Since the comparatively large thermal mass of the slates retains heat, the asphalt shingles are "cooked" from their backside as well as from their front when exposed to sunlight. The life of such shingles is estimated by some to be half the normal span.

Leaks in Slate Roofs

Slate roof leak (C) Daniel FriedmanAll slate roofs probably have at least some flashing, slate, or other damage or mechanical installation errors. Some conditions such as a side lap error, damaged slate, or even flashing error may leak only in certain weather conditions such as windy rain storms from a particular direction, water backup behind ice dams, or prolonged rains.

Where slates are missing near valleys the adjoining slates may be damaged as well.

Openings may cause leaks or water to pass below the valley flashing even if the flashing looks intact. Where there were previous repairs it's common for the felt underlayment to be torn as well. If there are porous slates or openings above the tears in the felt, water may leak through.

Ice dams at roof eaves can be a serious leak source on slate as most other roof systems. Traditionally 30# felt was used at eaves as "insurance" against this problem. Some slate suppliers recommend this heavier felt for all underlayment, not just at the eaves. However two components conspire to reduce the effectiveness of felt as ice-dam protection: every nail at the eaves punctures the felt, and with age felts often dry and disintegrate before the slates have worn out.

Ice dam protection is improved in new or re-roof applications using the newer sticky membranes such as WR Grace's Ice and Water ShieldTM.

However the preferred solution to this problem is proper attic ventilation. Good venting avoids the ice-dam problem and adds reductions in winter moisture and summer heat problems. Old houses whose attics have been converted to living space, particularly with un-vented ceilings following the underside of fully-insulated roofs are likely to be serious moisture and heat traps.

Slope requirements for slate roofs In conventional roofing design slates are used on roofs with a slope of at least 4" of rise in 12" of run, that is, on 4 in 12 roofs.

A 3" head lap is used, often 4" when the slope is less than 8 in 12. So a 20" long slate, with a 3" head lap, would have an exposure of 8.5".

Flat slate roof (C) Daniel FriedmanFor 18" slates the exposure is 7.5", and for 16" slates, 6.5". Roofs with less head lap or more exposure may be more leak-prone.

But slates have been used even on dead flat surfaces such as balconies and decks, as we show here.

When we inspected this slate covered deck in Newburgh, NY in 1991 we found that the slates had been set in a bed of tar over canvas to form a flat roof that lasted without leaking for nearly 50 years.

But as you can see in our photo, the slates had now come loose from their bed of tar.

This series of detailed slate roof inspection and repair articles describes procedures for evaluating the condition of slate roofing. How to inspect, identify defects, and estimate remaining life of slate roofs are addressed.

The article series also references slate repair procedures, repair slate sources, and slate quarries. An earlier version of this article appeared in the winter 1991 issue of the ASHI Technical Journal - the content has been edited and updated for this online version - March 2014. Copies of the ASHI Technical Journal are available from the American Society of Home Inspectors - ASHI at ashi.com.

More Reading

Green link shows where you are in this article series.

...




Frequently Asked Questions (FAQs) about the importance of recognizing the history of repairs to a slate roof

Reader comment:

Roof repair Specialist said:
Have you ever considered adding more videos to your blog posts to keep the readers more entertained? I mean I just read through the entire article of yours and it was quite good but since I'm more of a visual learner,I found that to be more helpful well let me know how it turns out! I love what you guys are always up too. Such clever work and reporting! Keep up the great works guys I've added you guys to my blogroll. This is a great article thanks for sharing this informative information.. I will visit your blog regularly for some latest post.

Reply:

Thanks Repair Specialist. We'll keep adding images and videos. I understand that often "a picture is worth a thousand words". We make more use of still photos than videos partly to be able to include explanatory text that one can read slowly, go back over and absorb , or write and criticize, and partly to be able to include references & citations.

Reader comment:

(Apr 12, 2014) Orlando Roof repair said:

Substantially, the article is really the best on this valuable topic. I concur with your conclusions and will thirstily look forward to your coming updates. Saying thanks will not just be sufficient, for the wonderful lucidity in your writing. I will instantly grab your rss feed to stay privy of any updates. Gratifying work and much success in your business efforts!

Reply:

Thanks so much Orlando Roof -

We've worked hard on this topic for a long time. You and all readers are welcome to help out with any content critique, suggestions, photos, or remarks, and of course we're glad to credit, cite, and link our readers to technical contributors.

Daniel Friedman, Ed.

Ask a Question or Search InspectApedia

Questions & answers or comments about assessing a slate roof condition by observing its repair history.

Use the "Click to Show or Hide FAQs" link just above to see recently-posted questions, comments, replies, try the search box just below, or if you prefer, post a question or comment in the Comments box below and we will respond promptly.

Search the InspectApedia website

HTML Comment Box is loading comments...

Technical Reviewers & References

Publisher's Google+ Page by Daniel Friedman

Click to Show or Hide Citations & References